Mast electrical service

Service Mast Installation
1. Install a listed wet location service head or goose neck on top of the service mast.
2. Install the service mast so that any condensation or water that enters can drain out before it gets to the service equipment or panelboard.
3. Form drip loops on each service wire.
4. Locate the service head or goose neck above the service wire attachment point. You may locate the service wire attachment point above the service head or goose neck if it is not more than (≤) 24 inches from the service head or goose neck and if it is not possible to locate the attachment point below the goose neck or service head.
5. Run each service entrance wire through a separate bushed opening in the service head or goose neck.

Mast electrical service

mast electrical service

Media:

mast electrical servicemast electrical servicemast electrical servicemast electrical servicemast electrical service

http://buy-steroids.org